Shave hair from the skin surface that you want to treat.
Clean your skin thoroughly from any hair residue and apply provided gel on the skin surface prior to use. (can be also used without the gel on a clean dry skin)
Before you start to use the device, clean the flash window (quartz lamp)
Plug in the power adapter to a power source and plug the other end to your device. When connected the screen will show “HR”.
Press and hold the power button for 3 seconds (the cooling fan will turn on and the display will show the remaining number of pulses).
A short press on the power button once at a time will switch between intensity level 1 to 8 and back down to 1 (it is recommended to follow the chart provided in this manual for intensity levels for each area).
The device uses a proximity sensor built-in the flash, and the pulse will work only with skin contact. (cover the flash window completely)
On the display make sure the “HR” is flickering, that means that the device is ready for the pulse. (if “HR” is not flashing the device will not emit light)
Press the Flash button, the device will flash one time. Lift device from the skin, wait till “HR” blinks again (takes 1-3 seconds) and repeat on area that was not treated.
When treatment is finished, press the power button for 3 seconds to turn off the device.
Clean the flash window (quartz lamp) with alcohol pad or moist wipes. (do not use water on the device)